EEASY-USB is a serial communication converter that convert the signal from the USB to a standardUARTTTLsignal and viceversa. EEASY-USB can be use to configure a EJH device that has an UART TTL serial port. Through the installation of a provided driver for yours OS the EEASY-USB will be configured as a standard communication port, this allow to use the EEASY-USB with any configuration software that exploit the serial standard port (COM1, COM2, etc ).

EK107USB is an interface able to implement a RS485 serial port by using a PC USB port. The available drivers will recognize the serial interface as a standard serial port; so the use of the product is directly allowed through any software able to communicate with the standard serial ports of the operating system (COM1, COM2, etc). RS485 and USB ports are isolated from each other at 1500 V.

ES107USB is an interface able to implement a RS485 serial port by using a PC USB port. The available drivers will recognize the serial interface as a standard serial port; so the use of the product is directly allowed through any software able to communicate with the standard serial ports of the operating system (COM1, COM2, etc). RS485 and USB ports are isolated from each other at 1500 V.

ES117P1 is a converter that realizes a serial connection via RS232, RS485 or TTL, using a USB port on the PC. Through the drivers the operating system treats the serial interface like a standard serial port, allowing the use of the converter through any software that can communicate with the standard serial ports present in the operating system (COM1, COM2, ecc.). RS232, RS485 and TTL ports are electrically isolated from the USB avoiding most of the problems of electrical noises.

EZ-4AI-D allows to acquire up to N.4 analogue inputs (ma or V) through a PLC with only digital input/output. The PLC interface is based on three PNP-type signals suited for connection to most PLCs available in the market. The interface is composed of a CLOCK signal generated by the PLC (transistor output), a DATA signal and STROBE signal generated by the module.

EZ-4TC-D allows to acquire up to N.4 Thermocouple sensors (J, K, E, N, S, R ,B ,T) through a PLC with only digital input/output. The PLC interface is based on three PNP-type signals suited for connection to most PLCs available in the market. The interface is composed of a CLOCK signal generated by the PLC (transistor output), a DATA signal and STROBE signal generated by the module.

EZ107 allows a transparent conversion and isolation of RS485/RS422 serial line into RS232 and viceversa.The RS232 connection is available both on terminals and RJ10 connector. As well the RS485 connection is available both on terminals and back side connector.